(1)please turns on the automobile starts the cowling, and takes down about front Headlight always becomes. In has the enough installment space under the situation, may not select front Headlight .
(2)opens Headlight always becomes Cover behind , takes out the halogen light bulb.
(3)with 25 millimeters cutters, in Cover behind center drills a hole.
(4)Takes down the set in the HID light bulb peripheral plastic cover.
Attention:
1,Installment, please note avoids any influence which the work area possibly creates.
2,do not have to use hand to touch light bulb, possibly can create the stain.
3,If the light bulb changes the internal organs, please uses to do the cloth piece or the ethyl alcohol cleans.
*Gently removes the plastic hat do not have to bump touches the vacuum tube
(5) loads the HID light bulb front headlight .
(6) The power source installment chart and the material are as follows.
※Please uses 20A the fuse
(Lower than 20A the fuse can starts in light bulb when blow a fuse)
*when the diode matches the line Loose , ' C' The region terminal should connect the cathode (-).
*In order to connect ' C' to the cathode, please (direction of current) ties hands behind the back the diode direction.
(7)First inserts the light bulb group of lines the rubber place, then loads always becomes cover behind. After, please shut tightly the big chimney. * Power source port installment method
Power source port installment method
(1)High-pressured start box insertion interior slot in.
(2)Connects the start box red line and the light bulb red line (+), similar connection start box heavy line and light bulb heavy line (-).
(3)Push to go into causes the rubber end it tightly to cover the metal end.
(8) With the two-sided rubber, the fixed buckle with the support the stabilizer in the engine compartment any reliable place
In when uses the relay, please refers following instruction
(1)in headlight cover behind middle, drills with the 25mm cutter and 8mm hits one hole.
(2)first inserts the relay line cable, like the chart, puts in the rubber place 大灯 always becomes cover behind 8mm Kong Zhong.
(9)Is connected the stabilizer group of lines and the light bulb group of lines.
(10)examines front two headlight whether works normally.
※If about at the same time the lamp is not bright or glitters, replaces above 70A the battery. The above question possibly is as a result of the power source power supply insufficiency.
