1.Careful! High-pressured danger! Possibly causes the electric shock injury!
2.When switch headlight power source, please do not have to contact light bulb, you can thermal Tang Shang which massively releases.
3.Does not want to be direct bare regards the light, the eye can burn?
4.When automobile accident please closes the power source, damages the high-pressured box, the line cable can divulge the high pressure, will be able to be extremely dangerous.
5.under any situation, please do not have to carry on opens solution and transformation, we will not be able to undertake any responsibility for this.
6.Needs to replace when and to repair, please to recent specialized organization seeks help.
7.Please note do not have to approach the flammable goods, for example paper, oil, atomization, paint, diluents and so on.
8.Please do not have burnt to move light to above, can seriously affect other drivers' safe dryings.
9.Please after starts the automobile, then turns on the headlight.
The operation pays attention:
*When you take down headlight from vehicle, please first careful reference manual After.
*Please carefully is reading the handbook, and then installs the Hid system.
*Not earnestly follows any injury which this instruction creates, we do not undertake its any responsibility.
1.In order to safely installs, please waits for the headlight and the engine completely cools.
2.Before the installment, please confirms the gear is in the neutral gear (or stops position)
3.Please guarantees when the installment the switch closes.
4.Careful do not have to scald, specially when switch headlight.
5.Careful do not have to beat and to scratch light bulb, do not have to use finger to touch light bulb, can create the stain.
6.Carefully inspects the coupling, the connection end, the wire connection. The wrong connection can cause the illumination to have the problem.
7.When in adjusts the light bulb, please do not have to let inside which the light bulb terminal meets touches headlight always becomes hide the light cover .
8.Please in headlight the resin or the rubber cover behind above drills 25mm the hole.
9.When connects the light bulb and the high pressure starter , do not have to meet in any case cathode.
10.When connects the stabilizer and the power source, do not have to meet in any case cathode. How installs the light bulb and the stabilizer
How installs the light bulb and the stabilizer
1.Please uses the two-sided rubber firmly fixed stabilizer, confirms side two is sturdy.
2.Please original halogen light bulb connection and power source connection. (Red meets +, black meets -).1. Confirms line cable cathode has not met instead.
The after installment finishes inspects
1.Confirms line cable cathode has not met instead.
2.When confirmation continually wiring cable is not too tight or is too loose, has not been extruded...
Recovers and operates
1.Guarantees for the part which install disassembles is assembled the home position.
2.Please inspects far near light whether works normally.
3.Please inspects other auto parts (lamp, automobile sound and so on) works normally.
The breakdown solves
1.Light bulb breakdown
*Thelight bulb crown high fever possibly melts inside covers.
*Solution: Please uses the spanner and inside covers in the light bulb peak has the 5mm space.
*Question: Possible to change the light the focal point. 2. The light gas2.Light gas
*The power supply importation insufficient possibly causes the light bulb to glitter or The air turn on electricity the effect is bad.
*Solution: The use attaches relay installment stable electric voltage.
*Question: Turns on when the headlight possibly has the noise.
